Forum

# saned -d128
[saned] main: starting debug mode (level 128)
[saned] read_config: searching for config file
[saned] read_config: done reading config
[saned] saned (AF-indep+IPv6) from sane-backends 1.0.22 starting up
[saned] do_bindings: trying to get port for service "sane-port" (getaddrinfo)
[saned] do_bindings: [1] socket () using IPv6
[saned] do_bindings: [1] setsockopt ()
[saned] do_bindings: [1] bind () to port 6566
[saned] do_bindings: [1] bind failed: Address already in use
[saned] do_bindings: [0] socket () using IPv4
[saned] do_bindings: [0] setsockopt ()
[saned] do_bindings: [0] bind () to port 6566
[saned] do_bindings: [0] bind failed: Address already in use
[saned] do_bindings: couldn't bind an address. Exiting.
[saned] FATAL ERROR; bailing out, waiting for children...
[saned] bail_out: all children exited

6566/tcp open sane_port

 cat /etc/sane.d/saned.conf
# saned.conf
# Configuration for the saned daemon
 
## Daemon options
# Port range for the data connection. Choose a range inside [1024 - 65535].
# Avoid specifying too large a range, for performance reasons.
#
# ONLY use this if your saned server is sitting behind a firewall. If your
# firewall is a Linux machine, we strongly recommend using the
# Netfilter nf_conntrack_sane connection tracking module instead.
#
# data_portrange = 10000 - 10100
 
 
## Access list
# A list of host names, IP addresses or IP subnets (CIDR notation) that
# are permitted to use local SANE devices. IPv6 addresses must be enclosed
# in brackets, and should always be specified in their compressed form.
#
# The hostname matching is not case-sensitive.
 
#scan-client.somedomain.firm
#192.168.0.1
192.168.1.1/99
#[2001:7a8:185e::42:12]
#[2001:7a8:185e::42:12]/64
 
# NOTE: /etc/inetd.conf (or /etc/xinetd.conf) and
# /etc/services must also be properly configured to start
# the saned daemon as documented in saned(8), services(4)
# and inetd.conf(4) (or xinetd.conf(5)).
+